Article number: | SPINMO |
Availability: | In stock (2) |
Does a mounting magnet not work on your hubs? Then this is the perfect solution!
The set consists of:
- 1 flat mounting plates with screw end and lock nut
- 1 bag of 2-component epoxy glue
- mixing stick
- The mounting plate with screw end is glued to the hub by means of flat mounting.
- The bonding takes place using a special 2-component epoxy glue.
- There is a lock nut on the screw end that ensures that the spinner cannot be tightened too far, which could damage it.
Assembly manual:
1 - For maximum strength, it is advisable to lightly sand the surfaces.
2 - Make the surfaces to be bonded thoroughly clean and free of grease.
3 - Mix the two components (resin and hardener 1:1) very well with the supplied mixing sticks
4 - Apply the glue evenly to both surfaces
5 - Place the spinner in the center of the hub within 2 minutes
6 - Make sure the spinner or hub does not move while drying out
7 - Allow the glue to harden for at least 1 hour
Use at your own risk!
Truckjunkie is not responsible for incorrect or incorrect installation and resulting damage.
NB! Spinners are not included